adjustable port valves
Can anyone explain the usage of the adjustable port valves? By adjusting the port size, we can change the valve capacity, right? To restrict the flow (when fully open) to a very low level, do we need a restrict orifice, or the adjustable port valve can do it itself?
Are you addressing a specific model that is described as an adjusable port valve?
The
port opening size is changing for all control valves compared to on/off
isolation valves. Also, valves are available with port size
selections. Many reduced port (bore) ball valves have a port one line
size smaller than the piping. Reduced port sizes for control valves
permit trim selection applied to specific process condition
ranges. However the valve internals must be replaced to change the port
size.
All three have adjuatable capacities by moving pivot points in the
linkage. The down side of that is when you set them to the low-end of
adjustable range, the trim is just not opening much. With the plug
close to the seat, erosion and wire-drawing are always phenomena that
might occur.
Groth has/had a tank-blanketing regulator with a
rotary-positionable cylinder around the trim so the user could dial in
the capacity he needs for the application. A window in the cylinder
could blank off part of the waterway so that the regulator's capacity
was adjustable.
As far as I know, it is a kind of valve with port height adjusting knob and port width positioning level to adjust the dimensions of the port. Just wondering if it has a full range of continuous throughput control from zero to max capacity, or just uncontinuously like valves with 1/4" trim, 3/8" trim, 1/2" ...
MORE NEWS