Needle Valve Series

Product drawing»

Structural drawing»

You are here: News > News Detail

valve driver

2011-06-23

I'm doing a project on driving a solenoid valve in BOSCH. The input is a
0-10V sine wave (Which is actually an output from a D/A converter) and
it is to be converted to a PWM signal of 300Hz with 0-100% range
dutycycle. This duty cycle is to be used to inject current to drive a
solenoid valve. For 100% dutycycle, the current should be ideally 1.4A
to close the valve completely.

Would using a micro controller give a more accurate PWM signal?
That wasn't clear from what you wrote.

 

MORE NEWS

Shanghai MeiYan Yi Pump & Valve Co., Ltd.
MeiYan Yi needle valve Contact MeiYan Yi
Shanghai Enine Pump & Valve Co., Ltd.
Enine needle valve Contact Enine
Shanghai Saitai Pump & Valve CO., Lid.
Saitai needle valve Contact Saitai
Shanghai Fengqi Industrial Development Co., Ltd.
FengQi needle valve Contact FengQi