It would always stall and would take forever to get started. it would not even move me when I sat on it and my son had to use his legs to get it started.

I have a small Hardinge gang tool lathe with 5C and use homemade nylon pullers with no problem. Get yourself a 3' length of 1-1/4 and bore the hole ~.025" under size then use a hack saw and cut a cros

Hose barbs with 10-32 threads. It isn't attached directly to the regulator or solenoid. The NV55 is attached to the side of the stand and hose is run to the solenoid on one side and hose attaches it t

Make sure the jet needle is going into the hole and make sure the throttle valve slides up and down freely. Also, make sure the retainer is holding the jet needle in place and not loose.

I just wanted to get some opinions on my choice of solenoid and check valve.I got the Burkett solenoid which was my first choice after I found out clippard are no longer quality built, I believe this

A system pressure drop FL460 Variable speed loader moment to work the system pressure between 1.0 ~ 1.6MPa, 1.0MPa when the pressure dropped to below, loader appears unable to work, walking difficulti

I would like to know if anyone know the part nr for the Pelagian needle valve. I know it

In any planted aquarium Carbon dioxide (CO2) is essential for better growth of plants. CO2 in the water comes from fish respiration, or is dissolved from the atmosphere.