In the project of connecting several multi-port selector valves to the flowmeter, is it necessary to install check valve at each individual multi port valve test line outlet? There are 5 multiport val

I'm still building my car, with a chevy v8 and moroso dry sump system. Since Moroso recommend that the tank is fitted "slightly higher" than the pump inlet I wondered if the oil from the tank could le

I need to lift condensate from a steam trap to a higher level (it is only 2 metres to discharge well and then drain to waste). Minimal pressure in steam main is 6 bar gauge.

I am reviewing a big water pump station with the main suction and delivery steel pipes of 2000 mm (yes 2 meter)and 1400 mm respectively.

My company uses a reciprocating screw set-up for injection molding of nylon 66. I have noticed that varying the cooling time parameter on the injection unit affects my melt cushion.

Using a cartridge style synchornizing flow divider/combiner between the valve and the cylinder. The standard D03 bang bang valve flows approx. 14 gpm wide open which is way to fast for this applicat

I have a following scenario I would like some technical help. Utility boiler with feedwater pump HP discharge side water hammer. There are one inlet and two discharge (HP and IP) for this FW pump.

How do anti siphon valves work? I'm told that you use these to shut-off a flow, when the flow is higher than normal. I'm googling a schematic to see how these work, but luck so far.