I want to find details as it concerns the load control on single shaft combined cycle power plants. I know that the steam turbine is engaged to the generaotr with a SSS clutch (synchro self sustaining

I'm converting a 'carb' car to EFI (Toyota) and need to add the fuel return line to the tank. Every one I have seen has entered from the top of the tank (along with the fuel pump line & fuel qty wirin

I will be running a water/glycol (basically a 50/50) mix through a vessel and filter. The solution will have approxiametly 100 ppm of chloride and a worst case scenario of ph 5. Maximum temperature

this are some applicable standards as tips however this document is old a decade! but may be helpful. just shearing.

Quick question. There is supposedly a forumla out there that helps you determine if you should stock a subcomponent or not. ie Do I want to stock break shoes or should we just stock the whole break as

I am working in a valve manufacturing company. we plan to change the material used for gate and plug valves.

this is a 9rta 76 engine. i am having problem with one of the showing low compression pressure. the peak pressure is normal.fuel valve and exhaust valve operation is ok.what can be the resons for low

Does anybody know any internet site where i can download a program for sizing safety-relief valves? I mean a kind of valve selector.